LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 537 (Automatic Transmission - 6L80/6L90 - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Control Valve Body Assembly Assemble >> Control Solenoid Valve Assembly Contact Gap Inspection

Control Solenoid Valve Assembly Contact Gap Inspection

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Control Solenoid Valve Assembly Contact Gap
GM1681608Courtesy of GENERAL MOTORS COMPANY
Control Solenoid Valve Assembly Contact Gap Inspection

Callout Component Name
1 Control Solenoid (w/Body and TCM) Valve Assembly
NOTE:

Inspect the contact area between the "heat sink" area of the control solenoid valve assembly and the valve body. There should be no visible gap. If a gap exists, loosen all 18 bolts and retighten in the required sequence.
scientia non olet · About LEMON Manuals