Center Support, Output Carrier and Output Shaft Removal (6L80/6L90)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Center Support, Output Carrier and Output Shaft Removal (6L80/6L90)
| Callout | Component Name |
|---|---|
| 1 | Center Support Retaining Ring
WARNING:
Use care when removing or installing the retaining ring. Ensure the J 45126 and DT 47773 are installed properly onto the retaining ring or bodily injury may occur. TIP: To release tension on the retaining ring, place the retaining ring flat on the floor and step on it, then remove the tool. Special Tools
For equivalent regional tools, refer to Special Tools . |
| 2 | Center (with 2-6 Low and Reverse Clutch) Support Assembly |
| 3 | Output Carrier Assembly and Output Shaft Assembly
CAUTION:
Ensure the DT 47786 is completely threaded into the output shaft assembly. Due to the weight of the assembly, incomplete threading may cause the assembly to break free from the DT 47786, causing component damage. Special Tool DT 47786 Output Carrier/Shaft Lifting Tool For equivalent regional tools, refer to Special Tools . |
| 4 | Output Shaft Thrust Bearing Assembly |