3-5 Reverse Clutch Housing Inspection Disassembled

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inspecting 3-5 Reverse Clutch Housing

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	1-2-3-4 and 3-5 Reverse Clutch Housing Assembly Procedure Apply soap compound to weld area of housing. Hold thumb over the air bleed passage. For disassembled 1-2-3-4 and 3-5 reverse clutch housing spray compressed air onto the housing / hub joint and inspect weld area for bubbles. If bubbles are detected a new housing is required.

Callout

Component Name

1-2-3-4 and 3-5 Reverse Clutch Housing Assembly

Procedure

Apply soap compound to weld area of housing.
Hold thumb over the air bleed passage.
For disassembled 1-2-3-4 and 3-5 reverse clutch housing spray compressed air onto the housing / hub joint and inspect weld area for bubbles.
If bubbles are detected a new housing is required.