Throttle Body Assembly Installation
WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
- Install the throttle body studs, as required. Tighten the throttle body studs to 6 N.m (53 lb in).
- Install the throttle body gasket (509) to the intake manifold. Align the locating tab of the gasket with the notch in the manifold.
- Install the throttle body (508), bolts (538), and nuts (507). Tighten the throttle body nuts and bolts to 10 N.m (89 lb in).
CAUTION:
Refer to Fastener Caution .
NOTE:
DO NOT use the throttle body gasket again. Install a NEW gasket during assembly.