Engine Prelubing

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

J 45299 Engine Preluber

For equivalent regional tools, refer to Special Tools .

Fig 1: View Of Engine Block Left Front Oil Gallery Plug

Courtesy of GENERAL MOTORS COMPANY

NOTE:

A constant and continuous flow of clean engine oil is required in order to properly prime the engine. Use an approved engine oil as specified in the owners manual.

Remove the engine oil filter and fill with clean engine oil.

CAUTION:

Refer to Fastener Caution .

Install the oil filter and tighten to 30 N.m (22 lb ft).
Locate the engine block left front oil gallery plug (116).
Install the M16 x 1.5 adapter P/N 509375.

Fig 2: View Of Engine Preluber

Courtesy of GENERAL MOTORS COMPANY

Install the flexible hose to the adapter and open the valve.
Pump the handle on the J 45299 preluber in order to flow a minimum of 1-1.9 liters (1-2 quarts) engine oil. Observe the flow of engine oil through the flexible hose and into the engine assembly.
Close the valve and remove the flexible hose and adapter from the engine.
Install the gallery plug to the engine and tighten to 60 N.m (44 lb ft).
Top-off the engine oil to the proper level.