LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 528 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Valve Rocker Arm Cover Removal - Left Side

Valve Rocker Arm Cover Removal - Left Side

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Ignition Coils & Bracket
    GM1402016Courtesy of GENERAL MOTORS COMPANY
  1. Remove the spark plug wires (724).
  2. Remove the ignition coil bracket studs (720).
  3. Remove the ignition coil and bracket assembly (719).
    4. Fig 2: View Of Bracket, Bolts, Coils & Wire Harness
    GM1402020Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect the ignition coil electrical connectors.
  5. Remove the bolts (723), coils (722), and wire harness (721) from the bracket (719), as required.
    6. Fig 3: View Of Valve Rocker Arm Cover
    GM1277108Courtesy of GENERAL MOTORS COMPANY
  6. Remove the valve rocker arm cover bolts and cover.
  7. If the valve rocker arm cover grommets are cracked or damaged, replace the valve rocker arm cover bolts. The grommet is serviced with the rocker arm cover bolt.
    8. Fig 4: View Of Valve Rocker Arm Cover Gasket
    GM1272820Courtesy of GENERAL MOTORS COMPANY
  8. Remove and discard the valve rocker arm cover gasket (504) from the cover.
scientia non olet · About LEMON Manuals