LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 528 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Valve Rocker Arm Cover Installation - Right Side

Valve Rocker Arm Cover Installation - Right Side

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Valve Rocker Arm Cover Gasket
    GM1272820Courtesy of GENERAL MOTORS COMPANY
    NOTE:
    • All gasket surfaces should be free of oil or other foreign material during assembly.
    • DO NOT use the valve rocker arm cover gasket again.
  1. Install NEW valve rocker arm cover grommets and use NEW valve rocker arm cover bolts if they are serviced with the grommet.
  2. Install a NEW gasket (504) into the valve rocker arm cover.
    3. Fig 2: Oil Fill Cap & Oil Fill Tube
    GM1559860Courtesy of GENERAL MOTORS COMPANY
  3. Install a NEW oil fill tube (423) to the valve rocker arm cover.
  4. Install the oil fill cap (424).
    5. Fig 3: View Of Valve Rocker Arm Cover & Bolts (Right)
    GM260084Courtesy of GENERAL MOTORS COMPANY
  5. Install the valve rocker arm cover onto the cylinder head.
    6. CAUTION:

    Refer to Fastener Caution .

  6. Install the cover bolts with grommets and tighten to 12 N.m (106 lb in).
    7. Fig 4: View Of Bracket, Bolts, Coils & Wire Harness
    GM1402020Courtesy of GENERAL MOTORS COMPANY
  7. Apply threadlock GM P/N 12345382 (Canadian P/N 10953489), or equivalent, to the threads of the ignition coil bolts (723).
  8. Install the ignition coils (722), wire harness (721), and bolts (723) to the bracket (719). Tighten the ignition coil bolts to 10 N.m (89 lb in).
    9. Fig 5: Ignition Coils & Bracket
    GM1402028Courtesy of GENERAL MOTORS COMPANY
  9. Apply threadlock GM P/N 12345382 (Canadian P/N 10953489), or equivalent, to the threads of the ignition coil bracket studs (720).
  10. Install the ignition coil and bracket assembly (719) and studs (720). Tighten the bracket studs to 12 N.m (106 lb in).
scientia non olet · About LEMON Manuals