LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 528 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Valve Rocker Arm Cover Cleaning and Inspection

Valve Rocker Arm Cover Cleaning and Inspection

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Valve Rocker Arm Cover
    GM1559813Courtesy of GENERAL MOTORS COMPANY
    IMPORTANT:
    • Do not use the valve rocker arm cover gasket again. Install a NEW gasket during assembly.
    • Remove the ignition coils before cleaning the cover in solvent. Do not submerge the ignition coils in solvent.
    • Do not remove the oil fill tube from the covers unless service is required. If the tube is removed from the cover, install a NEW tube (423) and seal (422) during assembly.
  1. Inspect the oil fill tube (423) for a loose fit or damage.
  2. Inspect the covers (505) for the following conditions:
    • Scoring or damage to the gasket surfaces
    • Ventilation system passages for restrictions
    • Threaded bolt holes for damage or debris
scientia non olet · About LEMON Manuals