LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 528 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Oil Pump, Screen and Crankshaft Oil Deflector Removal

Oil Pump, Screen and Crankshaft Oil Deflector Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pump, Screen & Crankshaft Oil Deflector
    GM2308314Courtesy of GENERAL MOTORS COMPANY
  1. Remove the oil pump screen bolt (2) and nuts (3).
  2. Remove the oil pump screen (4) with O-ring seal (1).
  3. Remove the O-ring seal from the pump screen.
  4. Discard the O-ring seal.
    5. Fig 2: View Of Crankshaft Oil Deflector
    GM260099Courtesy of GENERAL MOTORS COMPANY
  5. Remove the remaining crankshaft oil deflector nuts.
  6. Remove the crankshaft oil deflector.
    7. Fig 3: View Of Oil Pump & Bolts
    GM1658173Courtesy of GENERAL MOTORS COMPANY
  7. Remove the oil pump bolts (411).
    8. IMPORTANT:

    Do not allow dirt or debris to enter the oil pump assembly. Cap ends, as necessary.

  8. Remove the oil pump (413).
scientia non olet · About LEMON Manuals