Oil Pump, Screen and Crankshaft Oil Deflector Installation
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Align the splined surfaces of the crankshaft sprocket and the oil pump drive gear and install the oil pump (413).
- Install the oil pump (413) onto the crankshaft sprocket until the pump housing contacts the face of the engine block.
- Install the oil pump bolts (411) and tighten to 25 N.m (18 lb ft).
- Install the crankshaft oil deflector and nuts.
- Lubricate a NEW oil pump screen O-ring seal (1) with clean engine oil.
- Install the NEW O-ring seal onto the oil pump screen.
- Push the oil pump screen tube completely into the oil pump prior to tightening the bolt. Do not allow the bolt to pull the tube into the pump.
- Align the oil pump screen mounting brackets with the correct crankshaft bearing cap bolt/studs.
- Install the oil pump screen (4).
- Install the oil pump screen bolt (2) and the nuts (3).
- Tighten the oil pump screen bolt to 12 N.m (106 lb in).
- Tighten the crankshaft oil deflector nut to 25 N.m (18 lb ft).
NOTE:
Inspect the oil pump and engine block oil gallery passages. These surfaces must be clear and free of debris or restrictions.
CAUTION:
Refer to Fastener Caution .
NOTE: