LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 528 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Engine Front Cover Cleaning and Inspection

Engine Front Cover Cleaning and Inspection

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Gasket Sealing Surfaces & Bolt Holes
    GM1658228Courtesy of GENERAL MOTORS COMPANY
    NOTE:
    • Do not use the crankshaft front oil seal again. Install a NEW crankshaft front oil seal during assembly.
    • Do not use the front cover-to-engine block gasket again. Install a NEW gasket during assembly.
    • Do not use the camshaft position (CMP) actuator magnet gasket again. Install a NEW gasket during assembly.
  1. Clean the cover in solvent. Remove the sealant from the cover oil pan surface. Refer to Replacing Engine Gaskets .
    2. WARNING:

    Refer to Safety Glasses and Compressed Air Warning .

  2. Dry the cover with compressed air.
  3. Inspect the gasket sealing surfaces (1, 4) for excessive scratches or gouging.
  4. Inspect the threaded bolt holes (2, 3) for damaged threads or debris.
scientia non olet · About LEMON Manuals