LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 528 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Engine Coolant Air Bleed Pipe and Hole Cover Cleaning and Inspection

Engine Coolant Air Bleed Pipe and Hole Cover Cleaning and Inspection

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Coolant Air Bleed Pipe Seal
    GM1552485Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do not use the engine coolant air bleed pipe and cover seals again. Upon installation of the pipe and covers, install NEW seals.

  1. Remove the seals (308) from the pipe and covers.
    2. Fig 2: View Of Coolant Air Bleed Pipe Components
    GM1658230Courtesy of GENERAL MOTORS COMPANY
  2. Clean the pipe and covers in solvent.
    3. WARNING:

    Refer to Safety Glasses and Compressed Air Warning .

  3. Dry the pipe and covers with compressed air.
  4. Inspect the pipe and covers for restrictions within the pipe (1) or damaged sealing surfaces (2, 3).
scientia non olet · About LEMON Manuals