LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 528 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Engine Block Valley Cover Installation

Engine Block Valley Cover Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Engine Valley Cover
    GM1403316Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    All gasket surfaces should be free of oil or other foreign material during assembly.

  1. Lubricate the O-ring seals with clean engine oil.
  2. Install the O-ring seals (537) to the cover (555).
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the cover (555), gasket (556), and bolts (506). Tighten the manifold bolts to 25 N.m (18 lb ft).
    4. Fig 2: Removing/Installing Oil Pressure Sensor & Washer
    GM1403317Courtesy of GENERAL MOTORS COMPANY
  4. Apply sealant GM P/N 12346004 (Canadian P/N 10953480), or equivalent, to the threads of the sensor.
  5. Install the oil pressure sensor (706) and sealing washer (707). Tighten the sensor to 35 N.m (26 lb ft).
scientia non olet · About LEMON Manuals