Measuring the Cylinder for Oversize
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Adjust the micrometer to a dimension slightly smaller than the bore size. Refer to Engine Mechanical Specifications (RPO LMG VIN 0) , Engine Mechanical Specifications (RPO L9H) , Engine Mechanical Specifications (RPO L94 VIN F) , Engine Mechanical Specifications (RPO L96 VIN G) , Engine Mechanical Specifications (RPO LC9 VIN 7) .
- Insert the J 8087 gauge into the micrometer and zero the bore gauge dial.
- Use the J 8087
gauge and measure the cylinder bore for oversize.
Slide the bore gauge up and down throughout the length of the cylinder bore. Measure the bore, both parallel and perpendicular to the centerline of the crankshaft, at the top, center, and bottom of the bore. A cylinder bore that exceeds the maximum diameter must be serviced with an oversized piston. Refer to Engine Mechanical Specifications (RPO LMG VIN 0) , Engine Mechanical Specifications (RPO L9H) , Engine Mechanical Specifications (RPO L94 VIN F) , Engine Mechanical Specifications (RPO L96 VIN G) , Engine Mechanical Specifications (RPO LC9 VIN 7) .