LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 528 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Engine Block Cleaning and Inspection >> Inspection Procedure

Inspection Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the following components:
    • Cylinder walls for excessive scratches, gouging, or ring ridge
    • Cylinder bores for excessive ring ridge at the top of the cylinder
    • Coolant jacket for cracks
    • Valve lifter bores for excessive scoring or wear
    • Crankshaft bearing webs for cracks
    • Gasket sealing surfaces for excessive scratches or gouging

      Refer to Replacing Engine Gaskets .

    • Oil galleries for restrictions
    • Threaded bolt holes for damaged threads
    • Cylinder bores for excessive ring ridge at the top of the cylinder
  2. Measure the cylinder bores for an oversize condition:
scientia non olet · About LEMON Manuals