LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 528 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Cylinder Head Removal - Left Side

Cylinder Head Removal - Left Side

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Cylinder Head & Bolts
    GM1658150Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The cylinder head bolts are of a torque-to-yield design and are NOT to be used again. Install NEW cylinder head bolts during assembly.

  1. Remove the cylinder head bolts (220, 221).
    2. CAUTION:

    After removal, place the cylinder head on 2 wood blocks in order to prevent damage to the sealing surfaces.

  2. Remove the cylinder head (218).
    3. Fig 2: View Of Cylinder Head Gasket & Locating Pins
    GM1658153Courtesy of GENERAL MOTORS COMPANY
  3. Remove the gasket (217) and locating pins (230).
  4. Discard the gasket and cylinder head bolts.
scientia non olet · About LEMON Manuals