LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 528 (Engine Mechanical - 5.3L, 6.0L, 6.2L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Automatic Transmission Flex Plate Installation

Automatic Transmission Flex Plate Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Flex Plate & Bolts
    GM1658140Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The flex plate does not use a locating pin for alignment and will not initially seat against the crankshaft flange, but will be pulled onto the crankshaft by the engine flex plate bolts. This procedure requires a 3 stage tightening process.

  1. Install the flex plate to the crankshaft.
  2. Apply threadlock GM P/N 12345382 (Canadian P/N 10953489), or equivalent, to the threads of the flex plate bolts.
    3. Fig 2: Identifying Flywheel Bolt Tightening Sequence
    GM63174Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  3. Install the engine flex plate bolts.
    1. Tighten the engine flex plate bolts (1-6) a first pass in sequence to 20 N.m (15 lb ft).
    2. Tighten the engine flex plate bolts (1-6) a second pass in sequence to 50 N.m (37 lb ft).
    3. Tighten the engine flex plate bolts (1-6) a final pass in sequence to 100 N.m (74 lb ft).
scientia non olet · About LEMON Manuals