LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 525 (Engine Mechanical - Hybrid (LZ1) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Oil Level Indicator Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Level Indicator, Tube Bolt, Indicator Tube & O-Ring Seal
    GM1658141Courtesy of GENERAL MOTORS COMPANY
  1. Remove the oil level indicator (418).
  2. Remove the wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Right Side .
  3. Remove the oil level indicator tube bolt (419).
  4. Remove the oil level indicator tube (420) from the engine block.
    5. NOTE:

    The O-ring seal may be reused if not cut or damaged.

  5. Inspect the O-ring seal for cuts or damage.
  6. Remove the O-ring seal (421) from the tube, if required.
scientia non olet · About LEMON Manuals