Installation Procedure

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Oil Pressure Sensor, Washer And Valve Lifter Oil Filter

Courtesy of GENERAL MOTORS COMPANY

Apply sealant to the threads of the NEW oil pressure sensor. Refer to Adhesives, Fluids, Lubricants, and Sealers .

CAUTION:

Refer to Fastener Caution .

Using J 41712 oil pressure switch socket or equivalent, install the oil pressure sensor (706) and washer (707).
Tighten

Tighten the sensor to 35 (26 lb ft).

Fig 2: View Of Engine Harness Electrical Connectors & Inlet Hose Clamp

Courtesy of GENERAL MOTORS COMPANY

Connect the engine harness electrical connector (1) to the oil pressure sensor.
Tighten

Tighten the sensor to 35 (26 lb ft).
Install the intake manifold. Refer to Intake Manifold Replacement (RPOs LC9, LMG, LY5, L76) , Intake Manifold Replacement (RPOs LY2, LY6) , Intake Manifold Replacement (Except RPOs LY2, LY6, LC9, LMG, LY5) .