Installation Procedure

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Engine Mount

Courtesy of GENERAL MOTORS COMPANY

Position the engine mount to the engine.

Fig 2: View Of Engine Mount To Engine Bolts

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Refer to Fastener Caution .

Working through the wheelhouse opening, install the engine mount to engine bolts (1).
Tighten

Tighten the bolts to 50 N.m (37 lb ft).
Using the adjustable jack, lower the engine until the engine mount is sitting flush on the frame.
Remove the adjustable jack from the engine block.

Fig 3: View Of Engine Mount To Frame Bolts

Courtesy of GENERAL MOTORS COMPANY

Install the engine mount to frame bolts (1).
Tighten

Tighten the bolts to 65 N.m (48 lb ft) starting with the middle bolt then either side bolt.
Install the A/C compressor bracket. Refer to Air Conditioning Compressor Bracket Replacement (HP2) , Air Conditioning Compressor Bracket Replacement (Non-HP2) .
If the vehicle is equipped with 4WD, Install the front drive axle bracket and bolts.
Tighten

Tighten the bolts to 90 N.m (67 lb ft).
If the vehicle is equipped with 4WD, Install the front drive axle. Refer to Differential Carrier Assembly Replacement (9.25 inch) .
Install the exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side .