LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 525 (Engine Mechanical - Hybrid (LZ1) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Mount Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Mount
    GM1701535Courtesy of GENERAL MOTORS COMPANY
  1. Position the engine mount to the engine.
    2. Fig 2: View Of Engine Mount To Engine Bolts
    GM1701533Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Working through the wheelhouse opening, install the engine mount to engine bolts (1).

    Tighten 

    Tighten the bolts to 50 N.m (37 lb ft).

  3. Using the adjustable jack, lower the engine until the engine mount is sitting flush on the frame.
  4. Remove the adjustable jack from the engine block.
    5. Fig 3: View Of Engine Mount To Frame Bolts
    GM1701017Courtesy of GENERAL MOTORS COMPANY
  5. Install the left wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side .
  6. Lower the vehicle.
  7. Install the engine mount to frame bolts (1).

    Tighten 

    Tighten the bolts to 65 N.m (48 lb ft) starting with the middle bolt then either side bolt.

  8. Lower the vehicle.
  9. Install the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
scientia non olet · About LEMON Manuals