LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 522 (Steering Linkage System) >> Repair Instructions >> Steering Linkage Shock Absorber Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine shield, if equipped. Refer to Engine Shield Replacement .
    2. Fig 1: View Of Linkage Shock Absorber
    GM1862839Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Discard the steering linkage shock absorber nut.

  2. Remove the steering linkage shock absorber nut (1) from the steering linkage shock absorber (2).
    3. Fig 2: View Of Steering Damper Ball Stud, Relay Rod & J 24319-B
    GM397364Courtesy of GENERAL MOTORS COMPANY
  3. Remove the steering linkage shock absorber from the relay rod using J 24319-B  steering linkage and tie rod puller.
    4. Fig 3: View Of Linkage Shock Absorber
    GM1862840Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Discard the steering linkage shock absorber nut.

  4. Remove the steering linkage shock absorber bolt (2) and nut (3).
  5. Remove the steering linkage shock absorber (1) from the vehicle.
  6. Inspect the following parts:
    • The steering linkage shock absorber for leaks and damage
    • The steering linkage shock absorber bolt for damage or corrosion
scientia non olet · About LEMON Manuals