LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 522 (Steering Linkage System) >> Repair Instructions >> Steering Linkage Inner Tie Rod Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine shield, if equipped. Refer to Engine Shield Replacement .
  2. Remove the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
    3. Fig 1: Identifying Inner Tie Rod & Special Tool
    GM865341Courtesy of GENERAL MOTORS COMPANY
  3. Remove the steering linkage inner tie rod (1) from the relay rod using J 34028  inner tie rod wrench (2).
scientia non olet · About LEMON Manuals