Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Remove all traces of oil, grease, or other contaminants.
Clean the threads of the steering linkage inner tie rod with denatured alcohol or the equivalent and allow to dry.
Apply red LOCTITE™ threadlocker, GM P/N 12345493 (Canadian P/N 10953488) to the threads of the steering linkage inner tie rod.

Fig 1: Identifying Inner Tie Rod & Special Tool

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Refer to Fastener Caution .

Install the steering linkage inner tie rod (1) to the relay rod using J 34028 inner tie rod wrench (2) and tighten to 100 (74 lb ft).
Install the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
Install the engine shield, if equipped. Refer to Engine Shield Replacement .
Adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment .