LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 521 (Transfer Case - BW 4485 (Nr3)) >> Repair Instructions - On Vehicle >> Transfer Case Rear Extension Bushing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Cadillac Escalade EXT, 2012 Cadillac Escalade ESV, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Output Shaft Bushing And J 45380
    GM1549538Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Install the bushing with the notched area facing outward and properly aligned to the rear case. Oil pick up "slot" should be straight down in the vehicle.

  1. Using J-45380  transfer case rear bushing remover and installer install the output shaft bushing, if removed or new.
  2. Install the rear output shaft seal. Refer to Rear Output Shaft Seal Replacement .
scientia non olet · About LEMON Manuals