Installation Procedure
WARNING: This page is about a different car, the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Cadillac Escalade EXT, 2012 Cadillac Escalade ESV, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
- Install the transfer case onto a suitable transmission jack.
- Install a NEW transfer case gasket.
- Rotate the transfer case so that it is parallel to the torsion bar mounting bracket.
- Raise the transfer case into position.
- Rotate the transfer case so that it is aligned with the adapter.
- Install the transfer case to the adapter.
- Install the fuel pipe bracket onto the studs.
- Install the transfer case adapter nuts.
Tighten
Tighten the nuts to 50 N.m (37 lb ft).
- Install the transmission mount.
- Position the crossmember.
- Install the crossmember bolts.
Tighten
Tighten the bolts to 70 N.m (52 lb ft).
- Install the transmission mount nuts and bolts.
Tighten
Tighten the nuts and bolts to 40 N.m (30 lb ft).
- Remove the jack stand from the transmission.
- Install the front propeller shaft. Refer to Front Propeller Shaft Replacement .
- Install the rear propeller shaft. Refer to Rear Propeller Shaft Replacement .
- Fill the transfer case with fluid.
- Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
- Lower the vehicle.
NOTE:
When installing a new transfer case gasket, the gasket must be installed with the tab oriented up, and the yellow printing towards to front of the vehicle. Install the gasket without the use of any type of sealant or of lubricant.
CAUTION:
Refer to Fastener Caution .
NOTE:
Ensure that the gasket is flush to the transmission prior to installing the nuts.