LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 518 (Engine Exhaust System) >> Repair Instructions >> Exhaust Muffler Insulator, Hanger, and Bracket Replacement (LC9, LMG, LZ1, L20, L96) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Exhaust System Insulators
    GM1709436Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Do not use oil base lubricants.

  1. Apply a soapy solution to the following in order to ease the installation of the hanger (1):
    • The frame support bracket rod (2)
    • The inner diameter of the exhaust pipe hanger (1)
    • The exhaust pipe hanger rod (3)
  2. Press the exhaust pipe hanger (1) over the following:
    • The frame support bracket rod (2)
    • The exhaust pipe hanger rod (3)
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals