LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 518 (Engine Exhaust System) >> Repair Instructions >> Exhaust Muffler Insulator, Hanger, and Bracket Replacement (2500 Series) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Refer to Protective Goggles and Glove Warning .

WARNING:

Refer to Exhaust Service Warning .

NOTE:
  • Service the exhaust system insulators individually in order to retain the support for the exhaust system.
  • Do not use oil base lubricants.
    Fig 1: View Of Exhaust System Insulators
    GM1709441Courtesy of GENERAL MOTORS COMPANY
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Spray lubricant if necessary, onto the exhaust system insulator holes where the frame hanger and the exhaust hanger are inserted.
  3. Remove the exhaust system insulator (1), as required.
  4. If replacing the exhaust system insulator (2), remove the exhaust muffler assembly. Refer to Exhaust Muffler Replacement (LC9, LMG, LZ1, L20) , Exhaust Muffler Replacement (L96) , Exhaust Muffler Replacement (L94 with MWN) .
  5. Spray lubricant if necessary, onto the exhaust system insulator hole where the frame hanger is inserted.
  6. Remove the exhaust system insulator (2) from the frame hanger, as required.
scientia non olet · About LEMON Manuals