Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
- Drain the differential carrier assembly. Refer to Front Axle Lubricant Replacement .
- Remove the wheel drive shaft. Refer to Wheel Drive Shaft Replacement (2500) , Wheel Drive Shaft Replacement (1500) .
- Using a hammer and brass drift, disconnect the inner axle shaft from the differential case side gear.
- Remove the inner axle shaft housing nuts from the bracket.
- Remove the inner axle shaft housing bolts (2) from the differential carrier assembly.
- Remove the inner axle shaft (1) and inner axle shaft housing (4) from the vehicle.
- Remove the inner axle shaft housing gasket (3) from the inner axle shaft housing (4).
- Remove the inner axle shaft seal and the bearing from the inner axle shaft housing. Refer to Front Drive Axle Inner Shaft Seal and Inner Shaft Bearing Replacement (8.6/ 9.25 Inch Axle) .
- Using a hammer and a brass drift, remove the inner axle shaft.
NOTE:
If only replacing the right side inner shaft and/or housing, follow the steps below. If only replacing the left side inner shaft, proceed to step 10.