LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 516 (Front Drive Axle) >> Repair Instructions >> Front Drive Axle Inner Shaft Seal Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Drive Axle Inner Shaft Seal
    GM2529101Courtesy of GENERAL MOTORS COMPANY
  1. Position the NEW front drive axle inner seal (1) so that it is even in the front drive axle inner shaft housing.
    2. Fig 2: Installing New Axle Shaft Seal Using J 45225 & J 8092
    GM1486575Courtesy of GENERAL MOTORS COMPANY
  2. Using the J 45225  installer (1) and the J 8092  handle (2), if servicing the 8.25 inch axle, or J 44215  installer if servicing the 9.25 inch axle, install the front drive axle inner seal.
  3. Install the front drive axle inner shaft in the inner shaft housing. Refer to Front Drive Axle Inner Shaft and Inner Shaft Housing Replacement .
  4. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals