LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 516 (Front Drive Axle) >> Repair Instructions >> Front Axle Vent Hose Connector Replacement (9.25 Inch Axle) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Vent Hose Connector
    GM847064Courtesy of GENERAL MOTORS COMPANY
  1. Install the vent hose connector into the differential carrier assembly.

    Apply a small amount of sealer GM P/N 12346004 (Canadian P/N 10953480) or equivalent onto the threads.

    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the vent hose connector and tighten to 28 N.m (21 lb ft).
    3. Fig 2: View Of Vent Hose To Differential Carrier Assembly
    GM834272Courtesy of GENERAL MOTORS COMPANY
  3. Connect the vent hose to the vent hose connector.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals