Front Axle Lubricant Level Inspection (9.25 Inch Axle)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
- Make sure the vehicle is level.
- Inspect the front axle for leaks. Repair as necessary.
- Clean the area around the front axle fill plug.
- Remove the front axle fill plug (1).
- Inspect the oil level.
Specification
The 9.25 inch axle the oil level should be between 0-6 mm (0-0.25 in) below the fill plug opening.
- If the level is low, add oil until the level is between 0-6 mm (0-0.25 in) for the 9.25 inch axle. Use the correct fluid. Refer to Adhesives, Fluids, Lubricants, and Sealers .
- Install the fill plug and tighten to 33 N.m (24 lb ft).
- Lower the vehicle.
CAUTION:
Refer to Fastener Caution .