LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 516 (Front Drive Axle) >> Repair Instructions >> Differential Carrier Bushing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the differential carrier assembly. Refer to Differential Carrier Assembly Replacement (9.25 inch) .
    2. Fig 1: View Of Special Tools J 36616-2, J 33791-1, Thrust Bearing, J 21474-18 & Forcing Screw
    GM893247Courtesy of GENERAL MOTORS COMPANY
  2. Remove the upper differential carrier assembly bushing by performing the following steps:
    1. Install the J-36616-2 (1), the J-33791-1 (2), the thrust bearing (3), the J-21474-18 (4), and the forcing screw as shown.
    2. Remove the upper differential carrier assembly bushing by holding the forcing screw and slowly tightening the J-21474-18.
    3. Fig 2: View Of Special Tools 21474-18, Thrust Bearing, J 33791-1, J 36616-2, & Forcing Screw
    GM892847Courtesy of GENERAL MOTORS COMPANY
  3. Remove the lower differential carrier assembly bushing by performing the following steps:
    1. Install the J-21474-18 (1), the thrust bearing (2), the J-33791-1 (3), the J-36616-2 (4), and the forcing screw as shown.
    2. Remove the lower differential carrier assembly bushing by holding the forcing screw and slowly tightening the J-21474-18.
scientia non olet · About LEMON Manuals