LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 515 (Hybrid/EV Cooling System) >> Diagnostic Information and Procedures >> DTC P0C32 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that DTC P0A80, P0A81, P0A9C, P0A9D, P0A9E, P0AC6, P0AC7, P0AC8, P0ACB, P0ACC, P0ACD, P0AE9, P0AEA, P0AEB, P0BC1, or P0BDD is not set.
  2. Ignition ON, observe the scan tool BECM hybrid battery temperature parameters. The readings should be between -39 and +95°C (-38.2 and +203°F) with no greater than a 15°C (59°F) difference between any of the four temperature sensor readings. Refer to Temperature Versus Resistance .
  3. Using a scan tool, command the hybrid battery pack fan speed to 60 percent and let it run for 2 minutes.
  4. Observe the scan tool hybrid battery air inlet and outlet temperature parameters. The readings should be between -39 and +95°C (-38.2 and +203°F) with no greater than a 10°C (50°F) difference. Refer to Temperature Versus Resistance .
scientia non olet · About LEMON Manuals