LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 513 (Engine Controls/Fuel - Hybrid (LZ1) - DTC P0010 To DTC P0341) >> Diagnostic Information and Procedures >> DTC P0107 or P0108 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, open the hood to disable the Auto-Stop function. Refer to Hybrid Modes of Operation Description .
  2. Ignition ON, verify the scan tool hood position parameter displays Open.
  3. Engine running, observe the scan tool MAP Sensor parameter. The reading should be between 32-40 kPa.
  4. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals