LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 513 (Engine Controls/Fuel - Hybrid (LZ1) - DTC P0010 To DTC P0341) >> Diagnostic Information and Procedures >> DTC P0106 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

All electrical components and accessories must be turned OFF and allowed to power down.

  1. Verify the integrity of the air induction system by inspecting for the following conditions:
    • Any damaged components
    • Loose or improper installation
    • Improperly routed vacuum hoses
    • Any vacuum leak
    • Any type of restriction
    • MAP sensor seal that is missing or damaged
  2. Verify that restrictions do not exist in the MAP sensor vacuum source.
  3. Verify that restrictions do not exist in the exhaust system. Refer to Restricted Exhaust .
  4. Ignition OFF, disconnect the harness connector at the MAP sensor.
  5. Ignition OFF for 90 s or until the ECM powers down, test for less than 5 Ω between the low reference circuit terminal 2 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  6. Ignition ON, test for 4.8-5.2 V between the 5 V reference circuit terminal 1 and ground.
    • If less than the specified range, test the 5 V reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
    • If greater than the specified range, test the 5 V reference circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  7. Verify the scan tool MAP Sensor parameter is less than 12 kPa.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  8. Install a 3 A fused jumper wire between the signal circuit terminal 3 and the 5 V reference circuit terminal 1. Verify the scan tool MAP Sensor parameter is greater than 103 kPa.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
  9. If all circuits test normal, test or replace the MAP sensor.
scientia non olet · About LEMON Manuals