LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 512 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - DTC P0010 To DTC P0358) >> Diagnostic Information and Procedures >> DTC P0341 >> Component Testing

Component Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:

You must perform the Circuit/System Testing before proceeding with Component Testing.

  1. Inspect the camshaft position sensor for correct installation. Remove the camshaft position sensor from the engine and inspect the sensor O-ring for damage.
    • If the sensor is loose, incorrectly installed, or damaged, replace the camshaft position sensor.
  2. Connect the camshaft position sensor harness connector to the camshaft position sensor.
  3. Ignition ON, engine OFF, observe the Camshaft Position Active Counter parameter on the scan tool.
  4. Pass a flat steel object across the tip of the sensor repeatedly. The Camshaft Position Active Counter parameter should increment with each pass of the steel object.
    • If the parameter does not increment, replace the camshaft position sensor.
scientia non olet · About LEMON Manuals