Conditions for Running the DTC

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

DTCs P0016, P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0122, P0123, P0220, P0222, P0223, P0335, P0336, P0606, P0641, P0651, P1516, P2101, P2120, P2122, P2123, P2125, P2127, P2128, P2135, P2138, and P2176 are not set.
DTCs P0010 and P0011 are not set - without LU3.
The engine speed is less than 1, 000 RPM and DTC P0315 is set.
Engine run time is greater than 2 crankshaft revolutions.
The engine speed is between 375-5, 600 RPM.
The ignition voltage is between 9-32 V.
The engine coolant temperature (ECT) is between -7 and +130°C (+19 and +266°F).
When the startup ECT is colder than -7°C (+19°F), this diagnostic will be delayed until the ECT is warmer than +21°C (+69°F).
The fuel level is greater than 10 percent.
The ECM is not in fuel shut-off, or decel fuel cut-off mode.
The electronic brake control module (EBCM) and the traction control system (TCS) are not active or detecting rough road.
An automatic transmission shift with a throttle position greater than 95 percent is not occurring.
The power management is not active.
Excessive drive wheel slip is not detected.
The power take-off (PTO) is disabled, where applicable.
The cylinder deactivation is not in progress, where applicable.
DTCs P0300-P0308 run continuously when the above conditions are met.