LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 512 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - DTC P0010 To DTC P0358) >> Diagnostic Information and Procedures >> DTC P0016 (Without 6.0L or 6.2L) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

You must perform the Circuit/System Verification before proceeding with Circuit/System Testing.

  1. Inspect the engine front cover area, or review the service history of the vehicle for any recent repairs involving the timing chain, timing chain tensioner, camshaft, crankshaft, camshaft actuator, or sprockets.
    • If recent repairs were made, inspect the timing chain, timing chain tensioner, and both sprockets for proper timing alignment or indexing.
  2. Remove the engine front cover, refer to Engine Front Cover Replacement and inspect the timing chain, timing chain tensioner, and sprockets for wear or damage.
    • If any components are worn or damage, replace as necessary.
scientia non olet · About LEMON Manuals