LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 512 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - DTC P0010 To DTC P0358) >> Diagnostic Information and Procedures >> DTC P0011 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the CMP sensor and CMP actuator magnet jumper harness connector. Refer to INLINE HARNESS CONNECTOR END VIEWS - INDEX for connector identification.
    2. NOTE:

    Testing for steps 2-4 is performed on the ECM side of the jumper harness connector.

  2. Ignition OFF for 1 minute, test for less than 5 Ω between the low reference circuit terminal E and ground.
    • If greater than the specified value, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
    3. NOTE:

    A test lamp must be used for this test. The control circuit is pulled-up to a low current voltage, A voltage on the control circuit is normal.

  3. Ignition ON, engine OFF, verify that a test lamp does not illuminate between the control circuit terminal D and ground.
    • If the test lamp illuminates, test the control circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  4. Connect the DMM black lead to the control circuit terminal D. Connect the DMM red lead to B+. Set the DMM on the diode setting. Command the CMP actuator solenoid ON and OFF with a scan tool. The DMM should transition from OL when commanded OFF to less than 1 V when commanded ON.
    • If the circuit voltage does not correspond to the specified values, test the control circuit for an open/high resistance or a short to ground. If the circuit tests normal, replace the ECM.
    5. NOTE:

    Testing for steps 5 and 6 is performed on the engine side of the jumper harness connector.

  5. Ignition OFF, test for infinite resistance between the control circuit terminal D and ground.
    • If not the specified value, repair the control circuit for a short to ground.
  6. Test for 5.0-9.0 Ω between the control circuit terminal D and the low reference circuit terminal E.
    • If less than the specified range, test for a short between the control circuit and the low reference circuit. If the circuits/connections test normal, test or replace the CMP actuator magnet.
    • If greater than the specified range, test the control circuit and the low reference for an open/high resistance. If the circuits/connections test normal, test or replace the CMP actuator magnet.
  7. Remove the CMP actuator magnet. Perform the Camshaft Position Actuator Magnet Cleaning and Inspection . The CMP actuator magnet should pass the inspection.
    • If the inspection fails, replace the CMP actuator magnet.
  8. Perform the Camshaft Position Actuator Solenoid Valve Inspection (Off-Vehicle) , Camshaft Position Actuator Solenoid Valve Inspection (On-Vehicle) . The CMP Actuator Solenoid Valve should pass the inspection.
    • If the inspection fails, replace the CMP Actuator Solenoid Valve.
  9. If all circuits and components test normal, replace the mechanical CMP Actuator.
scientia non olet · About LEMON Manuals