LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Engine Controls And Fuel - 6.0L - Troubleshooting) >> Service Bay Test >> Test Procedure

Test Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: If the Service Bay Test aborts or fails a DTC will NOT be set.
  1. Install a scan tool.
  2. Select the Service Bay Test with the scan tool.
    3. CAUTION: Refer to Road Test Caution .
  3. Follow the instructions on the scan tool.
    • If the test aborts, correct the condition for running the test and then retest.
    • If the test fails, repair the vehicle for the condition indicated by the failure message on the scan tool.
  4. Verify that the EVAP I/M system status is set to YES.
scientia non olet · About LEMON Manuals