Circuit/System Testing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Observe the Engine DTC information with a scan tool. Verify no I/M DTCs are present.
- If an I/M DTC is set that would prevent the I/M System Status tests from completing, diagnose that DTC before continuing. Refer to Inspection/Maintenance (I/M) System DTC Table .
- Review applicable service bulletins for software updates that would prevent the I/M System Status tests from completing.
- If a control module re-program or other repair is required, perform the Inspection/Maintenance Complete System Set Procedure .
- Observe the I/M System Status indicators.
- If any I/M System Status indicators report NO, perform the Inspection/Maintenance Complete System Set Procedure .
NOTE:
Many DTC related repairs will instruct the technician to clear the DTC information. Clearing the DTC will reset the I/M System Status indicators to NO. Performing the I/M Complete System Set Procedure will set each of the I/M System Status indicators to YES.