Conditions for Running the DTC
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- DTCs P0030, P0050, P0053, P0059, P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0116, P0117, P0118, P0120, P0122, P0123, P0131, P0132, P0133, P0134, P0135, P0151, P0152, P0153, P0154, P0155, P0201-P0208, P0220, P0222, P0223, P0300, P0442, P0443, P0446, P0449, P0452, P0453, P0455, P0496, P0606, P0641, P0651, P1516, P2101, P2120, P2122, P2123, P2125, P2127, P2128, P2135, P2138, or P2176 are not set.
- A scan tool device control is not active.
- The intrusive diagnostics are not active.
- The engine overspeed protection is not active.
- The power take-off (PTO) is not active.
- Reduced power mode is not active.
- The traction control is not active.
- The engine is in Closed Loop status.
- The system voltage is between 10-32 V for greater than 4 s.
- The engine run time is greater than 100 s.
- The engine coolant temperature (ECT) is warmer than -20°C (-4°F).
- The engine speed is between 425-3, 500 RPM.
- The mass air flow is between 15-510 g/s.
- The fuel ethanol content is less than 87 percent.
- The DTCs run continuously once the above conditions have been met.