LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 508 (Engine Controls/Fuel - 5.3L, 6.0L, 6.2L - DTC P0420 To DTC P3449 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0449 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, engine OFF, command the EVAP vent solenoid Not Venting - On and Venting - Off with a scan tool. You should hear the solenoid click when commanded ON and OFF.
  2. Engine idling, command the EVAP vent solenoid ON and OFF with a scan tool while observing the following control circuit status parameters:
    • EVAP Vent Sol Ckt Short Gnd Test Status
    • EVAP Vent Sol Ckt Open Test Status
    • EVAP Vent Sol Ckt Short Volts Test Status

      Each parameter should display OK or Not Run.

  3. Operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.
scientia non olet · About LEMON Manuals