Transmission Fluid Cooler Flushing and Flow Test: Clean-up
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the main function switch (2) to the IDLE position and allow the supply vessel pressure to dissipate.
- Turn the main power switch (1) to the OFF position.
- Disconnect the supply and waste hoses and the 12-volt power source from the vehicle.
- Disconnect the air supply hose from J 45096 flush and flow test tool.
- Dispose of the waste ATF in accordance with all applicable federal, state, and local requirements.
NOTE:
A small amount of water may drain from the bottom of the unit when the air supply is disconnected. This is a normal operation of the built-in water separator.