LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 506 (Automatic Transmission - 6L80/6L90 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P2537 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X1 16 way harness connector at the transmission. Install the DT-47825-10  jumper harness to the X1 vehicle wire harness connector. Ignition ON.
  2. Verify a test lamp illuminates between X1 terminal 9 and ground at the transmission case.
    • If the test lamp does not illuminates and the circuit fuse is good 
    1. Ignition OFF.
    2. Test for less than 2 Ω in the Ignition Accessory circuit wire end to wire end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K9 Body Control Module.
    • If the test lamp does not illuminate and the circuit fuse is open 
    1. Ignition OFF.
    2. Test for infinite resistance between the Ignition Accessory circuit and ground.
      • If less than infinite resistance, repair the short to ground in the circuit.
    • If the test lamp illuminates 
  3. Replace the Q8 Control Solenoid Valve Assembly.
scientia non olet · About LEMON Manuals