LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 505 (Automatic Transmission - 2ML70 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Transmission Fluid Level and Condition Check >> Notes

Transmission Fluid Level and Condition Check: Notes

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start the engine and operate the vehicle for 15 minutes or until the transmission fluid reaches an operating temperature of 65-80°C (150-180°F).
  2. Park the vehicle on a level surface.
  3. With your foot on the brake, move the shift lever through each gear range. Pause for about 3 seconds in each range, ending in PARK.
  4. Apply the parking brake and let the engine idle for 3 minutes.
  5. Remove the transmission fluid level indicator. Wipe the indicator clean. Insert the indicator by pushing it back in all the way. Give the indicator a full twist in order to close.
  6. Wait 3 seconds and remove the indicator.
  7. Read both sides of the indicator. The fluid must be within the hot cross-hatched area using the lowest level reading.
scientia non olet · About LEMON Manuals