LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 504 (Automatic Transmission - 6L80/6L90 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Fluid Filler Tube and Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Transmission Oil Level Indicator
GM1284301Courtesy of GENERAL MOTORS COMPANY
  1. Unlock the transmission oil level indicator
  2. Remove the transmission oil level indicator.
    NOTE: Tie the engine wiring harness, between the oil level indicator tube and engine, to the engine, so when installing the new oil level indicator tube the harness will not get caught on the oil level indicator tube.
  3. Raise the vehicle.
  4. Support the transmission with a suitable jack.
  5. Remove the transmission crossmember.
  6. Remove the transmission oil level indicator tube bracket nut.
  7. Remove the exhaust heat shield from the transmission.
  8. Lower rear of transmission to allow for clearance to remove transmission oil level indicator tube.
  9. Remove the transmission oil level indicator tube from the transmission.
  10. Raise rear of transmission to allow for clearance to remove transmission oil level indicator tube from vehicle.
    11. Fig 2: View Of Oil Level Indicator Tube & Transmission Seal
    GM1869804Courtesy of GENERAL MOTORS COMPANY
  11. Remove the oil level indicator tube (1) and seal (2) assembly.
  12. Remove the seal (2) from the oil level indicator tube.
scientia non olet · About LEMON Manuals