LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 504 (Automatic Transmission - 6L80/6L90 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Generator Cooling Inlet Pipe & Generator Cooling Inlet Pipe Fitting
    GM1195424Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Discard the TOC retaining clip and install a new retaining clip.

  1. Install the TOC pipe into the TOC pipe fitting.

    A distinct snap should be heard or felt when assembling the TOC pipe to the fitting.

  2. To ensure the cooler line is properly installed, give the cooler pipe a gentle pull.
scientia non olet · About LEMON Manuals