LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 504 (Automatic Transmission - 6L80/6L90 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Park Pawl Actuator Guide and Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission fluid pan. Refer to Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement .
  2. Remove the case extension and gasket. Refer to the appropriate procedure:
  3. Fig 1: Park Pawl Actuator Guide And Guide Pin
    GM2699067Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Walk the pin out using side cutters or equivalent, then discard the pin.

  4. Remove the park pawl actuator guide pin (1).
  5. Remove the park pawl actuator guide (2).
  6. Remove and Discard the park pawl actuator guide seals (3).